Chattanooga Hydrocollator M-4 Mobile Heating Unit Features
- Chattanooga Hydrocollator M-4 Mobile Heating Unit is easy maintain and simple to fill and drain
- Requires just 20″ by 32″ floor space
- Extra large tank
- Oversized drain
- A second thermostat guards against low water level and overheating
- No plumbing required
- Uses 110 current, 12.5 amp
- Product weight: 132lb
- Product dimensions: 35″L x 20″W x 33″H (89cm x 51cm x 84cm)
- Also available (separately):
– Chattanooga Side Table Rack (code 4010)
– Chattanooga TM-1 Electric Lotion Warmer (code 4012)
– Chattanooga Dial Thermometer (code 4228SER)
– Chattanooga Extra Shelf (code 4230)
Instructions for Use
- Maintenance:
– Do not use bleach or cleaners with high chlorine content
– Do not use paper clips, safety pins, staples, coat hangers, etc., in, on, or near the unit
– Do not clean the unit with carbon steel wool or a carbon steel brush
– Use only soft cloth, Scotch-Brite type scouring pads of green, blue, or white abrasiveness, or stainless steel wool if absolutely necessary
– Do not use abrasive cleaners which tend to disturb the grain in the finish, especially on the exterior of the unit
– For exterior cleaning, use only non-abrasive stainless steel polish
– Water level is critical: Add water daily, if necessary, to keep unit full
– Regularly clean and drain the tank (every two weeks)
– Failure to properly maintain the unit will cause premature wear and will void the warranty
– Remove all deposits from interior surfaces and parts
– The deposits are concentrations of minerals that will allow rusting to begin
– If allowed to accumulate on the heating element, these deposits will lower the
efficiency of the element and increase the power consumption of the unit
– Exercise extreme care if cleaning the element or thermostat(s)
– These components can be easily damaged without proper care or caution
– If you suspect that you have hard waterÂ, you may need to change the water and clean the unit more frequently
– Salt deposits are an indication of hard water that will eventually cause rust - Cleaning Tips:
– Check for low or no chlorine content in your cleaner and make sure that the residue is thoroughly rinsed away with water
– strong solution of vinegar and water may be used to dissolve away deposits, which then must be thoroughly rinsed away
– Results may vary
– For exterior cleaning, use stainless steel polish and a soft cloth only
– Numerous industrial stainless steel polishes are available from various supply companies
– Use of any cleaner except stainless steel polish on the exterior of the unit is not recommended
– Abrasive cleaners and scouring pads can damage the finish of the unit
